Types of Research
- (-) Remove 2011 filter 2011
- (-) Remove 2013 filter 2013
- (-) Remove Education & Training filter Education & Training
- (-) Remove Global filter Global
- (-) Remove Sub-Saharan Africa filter Sub-Saharan Africa
- (-) Remove Aid & Other Development Finance filter Aid & Other Development Finance
- (-) Remove 2016 filter 2016
- (-) Remove Global & Regional Public Goods filter Global & Regional Public Goods
- (-) Remove 2014 filter 2014
This research considers how public good characteristics of different types of research and development (R&D) and the motivations of different providers of R&D funding affect the relative advantages of alternative funding sources. We summarize the public good characteristics of R&D for agriculture in general and for commodity and subsistence crops in particular, as well as R&D for health in general and for neglected diseases in particular, with a focus on Sub-Saharan Africa and South Asia. Finally, we present rationales for which funders are predicted to fund which R&D types based on these funder and R&D characteristics. We then compile available statistics on funding for agricultural and health R&D from private, public and philanthropic sources, and compare trends in funding from these sources against expectations. We find private agricultural R&D spending focuses on commodity crops (as expected). However contrary to expectations we find public and philanthropic spending also goes largely towards these same crops rather than staples not targeted by private funds. For health R&D private funders similarly concentrate on diseases with higher potential financial returns. However unlike in agricultural R&D, in health R&D we observe some specialization across funders – especially for neglected diseases R&D - consistent with funders’ expected relative advantages.
Common estimates of agricultural productivity rely upon crude measures of crop yield, typically defined as the weight harvested of a crop divided by the area harvested. But this common yield measure poorly reflects performance among farm systems combining multiple crops in one area (e.g., intercropping), and also ignores the possibility that farmers might lose crop area between planting and harvest (e.g., partial crop failure). Drawing on detailed plot-level data from the LSMS-ISA in Tanzania, Nigeria, and Ethiopia, we show how various yield measurement decisions affect estimates of smallholder yields for a variety of crops. We consider the effect of measuring production by plot area, area planted, and area harvested, of trimming the top 1% and 2% of values, and of considering different groups of farmers according to total area planted.
Household survey data are a key source of information for policy-makers at all levels. In developing countries, household data are commonly used to target interventions and evaluate progress towards development goals. The World Bank’s Living Standards Measurement Study - Integrated Surveys on Agriculture (LSMS-ISA) are a particularly rich source of nationally-representative panel data for six Sub-Saharan African countries: Ethiopia, Malawi, Niger, Nigeria, Tanzania, and Uganda. To help understand how these data are used, EPAR reviewed the existing literature referencing the LSMS-ISA and identified 415 publications, working papers, reports, and presentations with primary research based on LSMS-ISA data. We find that use of the LSMS-ISA has been increasing each year since the first survey waves were made available in 2009, with several universities, multilateral organizations, government offices, and research groups across the globe using the data to answer questions on agricultural productivity, farm management, poverty and welfare, nutrition, and several other topics.
This brief reviews the various definitions of global public goods (GPGs) and regional public goods (RPGs) found in the literature and provides examples of each in six frequently discussed sectors: environment, health, knowledge, security, governance, and infrastructure. We identify multiple alternative definitions that have gained some traction in the literature, but GPGs are generally agreed to exhibit publicness in consumption, distribution of benefits, and decision-making. Because policy choices determine what is and what is not a GPG, there cannot be a fixed list of such goods; some always have the property of global publicness, while others have over time changed from being local or national to being global in terms of benefits and costs. GPGs are thus redefined as goods that are in the global public domain. GPG and RPG financing mechanisms include payments by users and beneficiaries, taxes, fees, and levies, private funding by non-profit corporations, profit-making firms, and philanthropic individuals and organizations, national and international public resources, and partnerships between several sources of financing. We conclude with an analysis of trends in GPG and RPG financing through Official Development Assistance (ODA) using time series data from the OECD’s Creditor Reporting System and other sources. We find that 14% of ODA in 2014 was allocated to sub-sectors labelled by Reiner et al. as GPGs, while 15% of ODA was allocated to RPGs, and that GPG and RPG spending has steadily increased from 2002-2014.
This report summarizes current trends in the application of Development Finance Institution (DFI)-based returnable capital finance in developing countries, with an emphasis on “pro-poor” development initiatives. We begin by reviewing the financial instruments used by DFIs. We then review the major DFI providers of returnable-capital based finance, drawing on past and present peer-reviewed articles and published reports exploring trends in the uses of different returnable capital instruments over time. Finally, we conclude by further examining recent efforts to use returnable capital to finance development initiatives explicitly targeting the poor.
Cassava (Manihot esculenta Crantz) is a widely-grown staple food in the tropical and subtropical regions of Africa, Asia, and Latin America. In this brief we examine the environmental constraints to, and impacts of, smallholder cassava production systems in Sub-Saharan Africa (SSA) and South Asia (SA), noting where the analysis applies to only one of these regions. We highlight crop-environment interactions at three stages of the cassava value chain: pre-production (e.g., land clearing), production (e.g., soil, water, and input use), and post-production (e.g., crop storage). At each stage we emphasize environmental constraints on production (poor soil quality, water scarcity, crop pests, etc.) and also environmental impacts of crop production (e.g., soil erosion, water depletion and pesticide contamination). We then highlight good practices for overcoming environmental constraints and minimizing environmental impacts in smallholder cassava production systems. Evidence on environmental issues in smallholder cassava production is relatively thin, and unevenly distributed across regions. The literature on cassava in South Asian smallholder systems is limited, reflecting a crop of secondary importance (though it is widely found elsewhere in Asia such as South East Asia), in comparison to cassava in much of SSA. The majority of the research summarized in this brief is from SSA. The last row of Table 1 summarizes good practices currently identified in the literature. However, the appropriate strategy in a given situation will vary widely based on contextual factors, such as local environmental conditions, market access, cultural preferences, production practices and the policy environment.
This overview introduces a series of EPAR briefs in the Agriculture-Environment Series that examine crop-environment interactions for a range of crops in smallholder food production systems in Sub-Saharan Africa (SSA) and South Asia (SA). The briefs cover the following important food crops in those regions; rice (#208), maize (#218), sorghum/millets (#213), sweet potato/yam (#225), and cassava (#228).
Drawing on the academic literature and the field expertise of crop scientists, these briefs highlight crop-environment interactions at three stages of the crop value chain: pre-production (e.g., land clearing and tilling), production (such as water, nutrient and other input use), and post-production (e.g., waste disposal and crop storage). At each stage we emphasize environmental constraints on crop yields (including poor soils, water scarcity, crop pests) and impacts of crop production on the environment (such as soil erosion, water depletion and pest resistance). We then highlight best practices from the literature and from expert experience for minimizing negative environmental impacts in smallholder crop production systems.
This overview (along with the accompanying detailed crop briefs) seeks to provide a framework for stimulating across-crop discussions and informed debates on the full range of crop-environment interactions in agricultural development initiatives.
The purpose of this analysis is to provide a measure of marketable surplus of maize in Tanzania. We proxy marketable surplus with national-level estimates of total maize sold, presumably the surplus for maize producing and consuming households. We also provide national level estimates of total maize produced and estimate “average prices” for Tanzania which allows this quantity to be expressed as an estimate of the value of marketable surplus. The analysis uses the Tanzanian National Panel Survey (TNPS) LSMS – ISA which is a nationally representative panel survey, for the years 2008/2009 and 2010/2011. A spreadsheet provides our estimates for different subsets of the sample and using different approaches to data cleaning and weighting. The total number of households for Tanzania was estimated with linear extrapolation based on the Tanzanian National Bureau of Statistics for the years 2002 and 2012. The weighted proportions of maize-producing and maize-selling households were multiplied to the national estimate of total households. This estimate of total Tanzanian maize-selling and maize-producing households was then multiplied by the average amount sold and by the average amount produced respectively to obtain national level estimates of total maize sold and total maize produced in 2009 and 2011.
After cereals, root and tuber crops - including sweetpotato and yam (in addition to cassava and aroids), are the second most cultivated crops in tropical countries. This literature review examines the environmental constraints to, and impacts of, sweetpotato and yam production systems in Sub-Saharan Africa (SSA) and South Asia (SA). The review highlights crop-environment interactions at three stages of the sweetpotato/yam value chain: pre-production (e.g., land clearing), production (e.g., soil, water, and input use), and post-production (e.g., waste disposal, crop storage and transport). We find that sweetpotato and yam face similar environmental stressors. In particular, because sweetpotato and yam are vegetatively propagated, the most significant (and avoidable) environmental constraints to crop yields include disease and pest infection transmitted through the use of contaminated planting materials. Published estimates suggest yield gains in the range of 30–60% can be obtained through using healthy planting material. Moreover, reducing pest damage in the field can greatly increase the storage life of root and tuber crops after harvest – currently losses from rot and desiccation can claim up to 100% of stored sweetpotato and yam on smallholder farms.